We have a full color job that we run a couple times a year on our 4 color GTO. It is on 24pt. C1S and has always run without issues, but it takes a little work to get the press setup for running it. I also worry about damage caused from a jam, though it hasn't ever happened. The job is actually small cards that are around 4x6 inches that we run quite a few up on a 14x20 inch sheet. The quantity is usually only around 300-500 sheet so I am wondering if it would do any harm to try running some of this stock through out Xerox 560. I hoped that if I had the grain the right direction and ran a short and wide sheet, that it might feed it ok from the OHCF, but I don't want to do any damage to the imaging parts of the machine, like the fuser.
↧