Hi All
We run a Man Roland 704 1995 and have a problem upon start up
When we power up in the morning it goes through its motions and then shuts down and the green lights go off , although the monitor stays on and usually reads the below message
Failure of SPS
SPS-BUS Failure of SPS
SPS-BUS No data transmission
SPS-BUS Trouble when reading machine control data
SPS-BUS Trouble when sending data
It can take 3 or 4 power ups until it starts and will then be fine
Anybody out there had a similar problem and know a solution?
Any help appreciated
Thanks
We run a Man Roland 704 1995 and have a problem upon start up
When we power up in the morning it goes through its motions and then shuts down and the green lights go off , although the monitor stays on and usually reads the below message
Failure of SPS
SPS-BUS Failure of SPS
SPS-BUS No data transmission
SPS-BUS Trouble when reading machine control data
SPS-BUS Trouble when sending data
It can take 3 or 4 power ups until it starts and will then be fine
Anybody out there had a similar problem and know a solution?
Any help appreciated
Thanks