I am asking for some help or recommendation regarding the processing of Violet polymer plates
on Fuji Luxel VX9600. The unit has been calibrated by Fuji staff to process LP-NV plates.
We have tried to run a test with Agfa N91v. There is an Error message on the display. The plate is being forwarded to the online processor withoyt being exposed. On another unit with another software version the error message is specified as if the sensor cannot detect the plate edge. The slight deviation of the emulsion color between Agfa and Fuji plates may cause this. Is there a way to overcome this obstacle. Or is it inevitable to pay the amount Fuji staff wants to charge for a further plate set up.
on Fuji Luxel VX9600. The unit has been calibrated by Fuji staff to process LP-NV plates.
We have tried to run a test with Agfa N91v. There is an Error message on the display. The plate is being forwarded to the online processor withoyt being exposed. On another unit with another software version the error message is specified as if the sensor cannot detect the plate edge. The slight deviation of the emulsion color between Agfa and Fuji plates may cause this. Is there a way to overcome this obstacle. Or is it inevitable to pay the amount Fuji staff wants to charge for a further plate set up.