Quantcast
Channel: PrintPlanet.com
Viewing all articles
Browse latest Browse all 4279

Quality problems with Azura TS

$
0
0
Has anyone had any problems with Azura TS plates lately? I've been getting excessive amounts of pinholes and coating voids that were much bigger than pinhole size. Also deep scratches on the back of plates (out of the box, before imaging) where the end of the scratches would make a high spot on the back of the plate and cause a halo in the image. Since Pitman "reorganized" my new rep has not been around.

Just wondering if anyone else is experiencing the same thing.

Thanks

Scott

Viewing all articles
Browse latest Browse all 4279

Trending Articles